REFUSE TRUCK CYLINDERS
We match multi-stage cylinders to your refuse-truck ejector stroke, closed length, mounts, ports and hydraulic circuit.
REFUSE TRUCK TELESCOPIC HYDRAULIC CYLINDERS
TRUCK
CYLINDERS
We build multi-stage telescopic hydraulic cylinders for refuse-truck ejector and push-out systems that need a long working stroke inside a short body envelope. If you are replacing a cylinder in Brazil, Vietnam or Poland, send us the closed length, stroke, stages, mounts, pins, ports and circuit so we can match the cylinder to your truck body.
Refuse Truck Ejector
Wet-Service Protection
Legacy Truck Retrofit
Fitment & Inspection
Refuse Truck Ejector
Wet-Service Protection
Legacy Truck Retrofit
Fitment & Inspection
KEY CHALLENGES
CHALLENGES
Long Stroke in Limited Space
Closed length, extended length, ejector travel and mounting centers must be checked together inside the available truck-body envelope.
Uneven Stage Movement
Stage diameters, guide overlap and oil flow affect transitions, column support and impact at the end of the stroke.
Side Load and Misalignment
Worn guide rails or shifted brackets can transfer side load into the cylinder. We need the actual mounting geometry, not only the truck model.
Wet and Contaminated Service
Wash water, waste liquid, dust and road debris affect wipers, seals, stage surfaces and exterior coating.
Incomplete Retrofit Data
The same chassis can carry different bodies, mounts, ports and strokes. We verify your old cylinder and body drawings before production.
OUR SOLUTIONS
SOLUTIONS
We confirm retracted length, ejector travel, extended length, mounting centers and clearance before selecting the stage layout.
We review working pressure, acting type, hose routing, port threads and port orientation from your hydraulic schematic.
We size the stage count and diameters from your required stroke, closed length, push force, pressure and installation space.
We place clevises, pin eyes, trunnions, flanges, bushings and ports to the vehicle interface you approve.
We check the finished cylinder for dimensions, stage movement, pressure retention and external leakage against your acceptance points.
